Re: Introduction
Posted: Sat Feb 08, 2020 11:28 am
Hi and welcome.
I just sold 2 MZ-1F11 as I was having a clear out (under orders!!). The problem with them (at least the 2 I had) is the drive belt, it ages and stretches and thus the disk doesn't spin at the right RPM. I never got to change the belts but I did strip down the drives to clean them after buying and it is not so hard to change the belt. Getting the belt though, I couldn't source an original and I was going to get one from www.gbaudio.co.uk as they have a lot, basically you use a piece of string or cotton to size the belt and choose the profile (square, round, flat etc). I never got to complete this task though and sold them on before doing it.
I just sold 2 MZ-1F11 as I was having a clear out (under orders!!). The problem with them (at least the 2 I had) is the drive belt, it ages and stretches and thus the disk doesn't spin at the right RPM. I never got to change the belts but I did strip down the drives to clean them after buying and it is not so hard to change the belt. Getting the belt though, I couldn't source an original and I was going to get one from www.gbaudio.co.uk as they have a lot, basically you use a piece of string or cotton to size the belt and choose the profile (square, round, flat etc). I never got to complete this task though and sold them on before doing it.