MZ-SD2CMT - correct wiring?

hlide
Posts: 205
Joined: Thu Jan 25, 2018 9:31 pm

Re: MZ-SD2CMT - correct wiring?

Post by hlide » Tue Jan 15, 2019 2:02 pm

If the progress bar is not moving, it means the Arduino is in pause forced by the MZ-700 (MOTOR turned OFF). When trying to load, check if the SENSE signal is low and the MOTOR signal is high (motor on).

hlide
Posts: 205
Joined: Thu Jan 25, 2018 9:31 pm

Re: MZ-SD2CMT - correct wiring?

Post by hlide » Sun Feb 10, 2019 9:36 pm

tingo wrote:
Mon Dec 10, 2018 9:19 pm
This afternoon I tried again. Checked my wiring - it looks ok.
Marcus Lausch tried your configuration and it works perfect for him. So far, there are two people who has a working unit. I start to think your firmware is probably not working as expected as I remembered you had issues to build one that I never had.

He also tried other configurations like through QD drive or external and it works for him. I'm not certain he tries the ultra-fast mode though.

Here is the link on his website : https://www.marcuslausch.de/2019/02/05/ ... mz-sd2cmt/

Post Reply