10 posts • Page 1 of 1
The reason I ask is because I have some software which asks you to load SA-5510 first and then load the software. This software has its own Loader program which I've disassembled to the following:
There was a data block as well (which I haven't included here) which is copied into IBUFE by this code. So I was just trying to work out what on Earth it was doing as it clearly is making some changes to BASIC.
Code: Select all
LD A,67H LD (15B5H),A LD (15F1H),A LD (15FBH),A LD (16CEH),A LD (1621H),A LD HL,B028H LD DE,10F0H LD BC,0018H LDIR LD HL,1250H LD (2F3CH),HL LD SP,D000H JP 2F0DH
No, as I say, the instructions are to load BASIC SA-5510 first, then type in MON to get back to the Monitor and then you must load this 'loader' program. Just trying to transfer the software into MZF format but it's going to take a bit of work as there is no stored header on the tape (the loader program creates the header itself in the IBUFE locations in memory)