Page 1 of 1
Slave
Posted: Thu Nov 15, 2018 8:21 pm
by mz-80a
I have this program. Does anyone know what it's for?
Re: Slave
Posted: Fri Nov 16, 2018 9:24 pm
by mz-80a
Sorry I didn't have time to write a proper post last night. I have the tape of this program and it's published by Kuma (written by Apollo I guess). But I have no manual / instructions at all. If anyone can decipher what it is for that would be amazingly helpful!
Re: Slave
Posted: Fri Nov 16, 2018 9:38 pm
by mz-80a
Actually, just found this in a Kuma catalogue I have
:
- slave.png (106.08 KiB) Viewed 7515 times
So looks like it's an aid to assembly programming. Just need to work out the command set now !